Repair skirting boards, laminates and other holes with repair putty

Skirting boards and laminates are easily worn in everyday use – a vacuum cleaner may bump into them, children’s play can leave marks, or pets may damage the surface. Walls can also get holes and dents, for example when moving pictures.

Small dents and holes can be easily repaired with Maston Repair Putty. The putty is available in several shades, and by mixing them you can achieve a highly discreet finish. The putty can be sanded and painted if needed. For indoor use only (must not freeze).

In addition to skirting boards, the repair filler is suitable for laminate surfaces, stained wood, and even wet areas.

Watch the video or read the instructions on how to use the repair putty

Watch a short 49s video or read the five-step instructions below! You’ll find the products used at the end of the article.

Tools and materials needed when fixing small dents or holes

• Maston Repair Putty
• Sandpaper (grit 180) or a sanding machine
• Maston Degreaser
• Masking tape
• Protective paper or plastic
• Protective equipment (mask, gloves, safety glasses)

Step-by-Step instructions on how to use the repair putty to fix small dents and holes

1. Preparation

• Make sure the surface is suitable for treatment.
• Protect surrounding areas that should not be treated.
• Prepare the filler and spatula.

2. Clean and sand the surface

• Thoroughly clean the area to remove grease and dirt.
• Lightly sand the surface with 180-grit sandpaper to improve adhesion.
• Wipe the surface with degreaser.

3. Apply the Repair putty

• Apply the putty directly to the surface or to the spatula and spread it
• Fill the hole evenly. Apply multiple layers if needed, allowing each layer to dry before adding the next.
• Choose a suitable shade or mix shades to match the surface.
• Clean tools after use.
• Note: When repairing laminate, match the shade carefully. Sanding is usually not required.

4. Drying

• Drying time depends on layer thickness and conditions.
• A thin layer becomes touch-dry in approximately 15 minutes.
• Indicative drying rate is about 2 mm per hour.

5. Finishing

• Once fully dry, remove all protective coverings.
• Clean up the workspace and finish the surface by sanding or painting if needed.

Tips for best results

• Work in a well-ventilated area.
• Test the shade on an inconspicuous area first.
• Take your time with each step to ensure a high-quality result.

By following these instructions, you can easily refresh your home’s appearance without major renovations. Small repairs are a cost-effective and simple way to keep your home in good condition.

Maston products outside of Finland: please check your local retailers. Retailers are found all around Europe!